Blue Sky I/ON
In-Wall / On-Wall Passive Studio Monitor
Studio MonitorPrice not published
Specifications
- Type
- Studio Monitor
- Description
- In-Wall / On-Wall Passive Studio Monitor
- Topology
- 2-way passive, sealed-box, 4th-order crossover
- Signal path
- Analog
- Channels
- 1
- Form factor
- In-wall, on-wall, or in-ceiling mount; fully sealed enclosure, mountable vertically or horizontally
- Connection
- speaker-level (passive; requires external amplifier)
- DSP
- no
- Powered
- passive
- Drivers
- 6.5" hemispherical cast-aluminum-frame woofer (1.5" aluminum voice coil, mica-filled polypropylene cone) + 1" dual concentric diaphragm tweeter with integral wave-guide
- Frequency response
- 80 Hz-20 kHz +/-3 dB
- Sensitivity
- 85 dB SPL (2.82V RMS)
- Impedance (Ω)
- 6 ohms nominal / 5.5 ohms minimum
- Back design
- solid MDF sealed enclosure (1.5" front baffle / 0.625" rear baffle); OmniMount type 60 / Powerdrive type 100 bracket inserts
Details
I/O: top/bottom spring-loaded vibration-proof solid metal terminals (passive speaker-level input, no line-level or digital I/O)
Notes: FLAG: this model is PASSIVE (powered=passive), outside the brief's core 'active studio monitors' scope, but it is a current (non-discontinued), in-scope-category Studio Monitor product still listed on abluesky.com, so it is included. Requires external amplification; spec sheet recommends 100-200W amplifier power (not the unit's own power_watts, left blank since I/ON has no internal amp). 2nd-order 80Hz acoustic roll-off is designed to integrate with Blue Sky subwoofers/bass-management (AMC) or a 5.1 receiver/preamp for use as an LCR/surround satellite. Crossover point given as 2.0kHz. Country of manufacture not stated on spec sheet/manual (left blank, unlike SAT 6D/SUB 12D which explicitly state USA assembly).